| 1. Remove stool. |
A. Remove two bolts, one on each
side.
B. Remove water line located at the rear of stool.
( MAKE SURE WATER IS OFF )
|
| |
| 2. Locate
flush line between vacuum breaker and bowl. |
A.
Next separate the top from the bottom.
1. Remove eight (8) screws from under
rim.
2. Gently pry apart. [Photo 2A]
|
2A
|
B. Cut a small section out of flush line.
( Between two smooth sections.)
C. Using a hair dryer, warm plastic line so it can easily
slip over T-valve. The arrow on the T-valve should point toward
the bowl.
( THIS IS VERY IMPORTANT )
D. With the two clamps provided, secure T-valve in place. [Photo
2B-D]
|
2B-D
|
E. At the back of the base, drill a 11/32 hole in the flat
section for line supply.
F. Feed line through hole.
( A tight fit is necessary to avoid any
leaks.) [Photo 2E-F]
|
2E-F
|
G. Reassemble stool making sure blade spring
is in place.
H. Reattach ¼ line to reservoir. Apply silicone on stem.
|
| |
3. Reinstall stool making sure all gaskets,
bolts and water
connections are secure.
|
| 4. Mounting the dispenser on the wall. |
A. Locate reservoir to the
back or side of the wall providing easy access for filling.
B. Keep level or lower than back of stool.
C. Screw reservoir into place with the three screws provided
with the kit.
|
| |
| 5. FINAL CHECK LIST |
A. Check water lines for
leaks.
B. Check stool by flushing.
C. Add a few ounces of Blue
Streak Chemical® to reservoir.
D. Flush Stool. Finish filling reservoir.
|
|
6.
Q: How Do I Winterize the Blue Streak Dispenser?
|
A: Run
the chemical level low [1to 2 inches] in the reservoir and
winterize your unit as you would normally. To remove chemical from
the reservoir; unscrew the tank from the wall leaving tubing
attached to tank and pour chemical into another container.
|
