A. Remove two bolts, one
on each side.
B. Remove the water line located at the rear of the stool.
( MAKE SURE WATER IS OFF )
2.
Locate flush line between vacuum breaker and bowl.
A. Flush line is located to left
rear of stool. [Photo View A]
B. Remove Water Module
Link and discard. [It is the corrugated line.]
C. Use the two pieces of ˝ inch id clear vinyl tubing
provided in kit, one 1˝
inch long and one 2˝ inch long.
D. With the clamps provided, secure
the two pieces with the arrow pointing towards the longest. [Photo View B]
E. Insert assembly through the
hole [Photo View C] and attach the nozzle assembly. (No
clamp needed)
Slide the other end over nipple at the Water Module and clamp. ( [Photo View D]
Snap nozzle assembly in place.
3.
Reinstall stool, making sure all gaskets, bolts and water connections
are secure.
4.
Mounting the dispenser reservoir to the wall.
A. Locate reservoir to the
back or side wall providing easy access for filling.
B. Keep reservoir lower than back of stool.
C. Screw reservoir into place with the three screws provided
with kit.
5.FINAL CHECK LIST
A. Check water
line for leaks.
B. Check stool by flushing.
C. Add a few ounces of Blue
Streak Chemical® to
reservoir.
D. Flush stool. Finish filling reservoir.
6. Q: How Do I Winterize the
Blue Streak Dispenser?
A: Run
the chemical level low [1to 2 inches] in the reservoir and
winterize your unit as you would normally. To remove chemical from
the reservoir; unscrew the tank from the wall leaving tubing
attached to tank and pour chemical into another container.
Blue
Streak Chemical™, Blue Streak™ owned by Blue Streak L.L.C.
All other
products mentioned are registered trademarks or trademarks of their
respective companies.
Questions or problems regarding this web site should be directed to cls@bluestreakchem.com
Copyright Blue streak L.L.C. All rights reserved.
Last modified: Tuesday June 17, 2008.
