| |
|
INSTALLATION
INSTRUCTIONS
Thetford Aria (2003 and Newer)
Single Vacuum Breaker Model |
| |
| 1.
Remove the stool. |
A. Remove two bolts, one on each
side.
B. Remove the water line located at the rear of stool.
(MAKE SURE
WATER IS OFF).
C. Unhook wires to stool.
|
| |
|
2. Locate flush line between vacuum breaker and bowl.
A. Cut the flush line half way
between vacuum breaker and bowl. [Photo View 1]
B. Insert T-valve with small arrow pointing toward the bowl. [Photo View
2]
THIS IS VERY IMPORTANT
(T-valve will not work if installed
backwards)
C. With the two hose clamps enclosed in kit secure T-valve in place.
[Photo View 3]
|
|
[View 1]
|
[View 2]
|
[View 3]
|
| |
| 3. Reinstall stool making sure all gaskets, bolts and water
connections are secure. Reattach the wires. |
| |
| 4. Mounting the dispenser reservoir to the wall. |
A. Locate reservoir to the back or side of the wall providing
easy access for filling.
B. Keep level or lower than back of stool.
C. Screw reservoir into place with the three screws provided.
|
| |
| 5. FINAL CHECK LIST |
A. Check water line for leaks.
B. Check stool by flushing.
C. Add a few ounces of Blue Streak Chemical to reservoir.
D. Flush stool. Finish filling reservoir.
|
|
|
|
6. Q:
How do I winterize the Blue Streak Dispenser?
|
A: Run the
chemical level low [1to 2 inches] in the reservoir and winterize your
unit as you would normally. To remove chemical from the reservoir;
unscrew the tank from the wall leaving tubing attached to tank and pour
chemical into another container.
|
