| 1. Remove stool. |
A. Remove
front cover at base of stool.
A. Remove two bolts, one on each
side.
B. Remove water line located at the rear of stool.
( MAKE SURE WATER IS OFF )
|
| |
| 2. Locate
flush line between vacuum breaker and bowl. |
A.
Flush Line enters back of stool going to the bowl.
B. Cut
line about half way.
C.
Install T-valve with arrow pointed toward the bowl.
D. With
the clamps provided, secure T-valve in place.
[Photo View 1]
|
View 1
|
| 3.
Reinstall stool making sure all gaskets, bolts, water
connections and front cover are secure. |
| |
|
4.
Mounting the dispenser on the wall.
A.
Locate reservoir to the back or side wall, providing easy access
for filling.
B. Keep
reservoir lower than the stool. [Photo View 2]
C. Screw reservoir into place with three screws provided with
kit.
|
View 2
|
| |
| 5. FINAL CHECK LIST |
A. Check water lines for
leaks.
B. Check stool by flushing.
C. Add a few ounces of Blue
Streak Chemical® to reservoir.
D.
Flush stool. Finish filling reservoir.
|
|
|
|
6. Q: How Do
I Winterize the Blue Streak Dispenser?
|
A: Run
the chemical level low [1to 2 inches] in the reservoir and
winterize your unit as you would normally. To remove chemical from
the reservoir; unscrew the tank from the wall leaving tubing
attached to tank and pour chemical into another container.
|
