- Remove stool.
- Remove two bolts, one on each side.
- Remove water line located at the rear of stool. (MAKE SURE WATER IS OFF)
- Locate flush line between vacuum breaker and bowl.
- Next separate the top from the bottom.
- Remove eight (8) screws from under rim.
- Gently pry apart. [Photo 2A]
- Cut a small section out of flush line. (Between two smooth sections.)
- Using a hair dryer, warm plastic line so it can easily slip over T-valve. The arrow on the T-valve should point toward the bowl. (THIS IS VERY IMPORTANT)
- With the two clamps provided, secure T-valve in place. [Photo 2B-D]
- At the back of the base, drill a 11/32 hole in the flat section for line supply.
- Feed line through hole. (A tight fit is necessary to avoid any leaks.) [Photo 2E-F]
- Reassemble stool making sure blade spring is in place.
- Reattach ¼ line to reservoir. Apply silicone on stem.
- Next separate the top from the bottom.
- Reinstall stool making sure all gaskets, bolts and water connections are secure.
- Mounting the dispenser on the wall.
- Locate reservoir to the back or side of the wall providing easy access for filling.
- Keep level or lower than back of stool.
- Screw reservoir into place with the three screws provided with the kit.
- FINAL CHECK LIST
- Check water lines for leaks.
- Check stool by flushing.
- Add a few ounces of Blue Streak Chemical® to reservoir.
- Flush Stool. Finish filling reservoir.
|
|
|
Q: How Do I Winterize the Blue Streak Dispenser?
A: Run the chemical level low [1 to 2 inches] in the reservoir and winterize your unit as you would normally. To remove chemical from the reservoir; unscrew the tank from the wall leaving tubing attached to tank and pour chemical into another container.